Setup a 1um and 2pm with 2 S3 storages, 1 per PM. After the system successfully came up. I ran the some of the mcsadmin storage commands to see what was displayed. 'config' shows the type of storagemanager, but it would be nice if it also showed the S3 names that could be read from storagemanager.cnf file.

Also the status shows not configured. I guess this doesnt apply for S3 storage, maybe a message should give that info.

And the getsystemdisk doesnt show S3 disk usage and availability. Dont know if this can work on S3, but it would be nice.

I also know that this OAM code is going away in future release, so I have no idea if these type of commands will exist. But worth opening an issue on what I think would be nice to have

mcsadmin> getStorageConfig
getstorageconfig Thu Apr 23 16:03:05 2020

System Storage Configuration

Performance Module (DBRoot) Storage Type = storagemanager
System Assigned DBRoot Count = 2
DBRoot IDs assigned to 'pm1' = 1
DBRoot IDs assigned to 'pm2' = 2

mcsadmin> getStoragestatus
getstoragestatus Thu Apr 23 16:03:11 2020
System External DBRoot Storage Statuses

Component Status Last Status Change
------------ -------------------------- ------------------------
No External DBRoot Storage Configured

mcsadmin> getSystemDisk
getsystemdisk Thu Apr 23 16:08:13 2020

System Disk Usage per Module

Module 'um1' Disk Usage (in 1K blocks)

Mount Point Total Blocks Used Blocks Usage %
----------------------------- ------------ ------------ -------

Module 'pm1' Disk Usage (in 1K blocks)

Mount Point Total Blocks Used Blocks Usage %
----------------------------- ------------ ------------ -------

Module 'pm2' Disk Usage (in 1K blocks)

Mount Point Total Blocks Used Blocks Usage %
----------------------------- ------------ ------------ -------